ActionTec PC-260 User's Guide download pdf (Page 22)

Installing the Hardware

Page 22

Set the Switches or Jumpers and

Install the Board

Every board installed in your computer must have a unique address for

transferring information to and from the board. If the ISA Bus Board is

the only expansion board in your PC, or if there are no I/O address

conflicts with other boards, you don’t need to change the switch setting

and may skip to Install the Card Socket Module.

Depending on the configuration, you will either have to set the switch

block or Jumper block to configure the ISA card. This will either

consist of setting the banks of switches or jumpers. They are located

on the ISA Bus Board. Switches 5, 6, and 7 control the I/O address,

while jumpers J300-305 control the I/O address configuation depending

on the ISA card.

In most cases, you won't need to change the factory setting. The

following illustration show the factory setting for Card Reader card

model.

The following illustration identify the switch block location on the ISA

board.

Card Reader Switch Block Location

1. Locate the switch block on the ISA Bus Board.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 84 85

No comments

ActionTec PC-260 User's Guide Page 22