ActionTec PC-260 User's Guide download pdf (Page 29)

Home
ActionTec
Networking
PC-260
User's Guide

Download
Share

Sharing
Add to my manuals
Print

Installing the Hardware

PC-250, PC-260, and PC-300 User’s Guide Page 29

The cables must not be twisted. The following drawing shows, in a

simplified form, how to connect the cables.

3. Double check all connections.

NOTE

The connectors on the ISA card are keyed to the flat

ribbon cable. Make sure you check the red stripe

indicating Pin 1 with the correct card connector key.

Correct Cable Connections

• One ribbon cable should connect from the Card Socket Module to

the socket on the ISA Bus Board.

• The other ribbon cable should connect from the socket on the Card

Socket Module to the socket on the ISA Bus Board.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 84 85

Proprietary Notice and 1
Disclaimer 1
Software License Agreement 1
Table of Contents 4
Quick Start 6
Assumptions 6
Requirements 6
Unpacking and Registering 7
Install the Card Reader 8
Install the Software 9
WARNING 10
CardTalk Control Panel 10
DOS Utilities 10
Introduction 11
The Card Reader 12
Package Contents 13
System Requirements 13
This Guide 14
PC Cards 15
Socket Services 16
Card Services 16
Super Client Driver 16
Enablers 17
Terminology 17
Installing the Hardware 19
Preparation 19
Disassemble the Computer 20
Discharge Static Electricity 21
Install the Board 22
DIP Switch / Jumper Settings 23
Page 24 24
Identifying the Sockets 30
What to Do Next 31
Installing the Software 33
Run INSTALL 34
Custom Installation 35
Setting the ATA I/O Address 36
Enabling the Annunciator 37
Selecting a Serial Port 38
Page 40 40
Completing Installation 41
Page 42 42
Verify the Installation 43
Observe the Messages 44
Page 46 46
CardTalk Files 47
CAUTION 48
Using PC Cards 49
Applications Software 50
Removing a Card 50
Cards that Require Only 51
CARDTALK.SYS 51
Fax/Modem Cards 51
Fax/Modems Supported 52
CARDTALK.386 53
Setting the COM Port 53
When to Insert the Fax/Modem 53
ATA Devices 54
Device Limitations 55
Solid State ATA Flash Cards 55
Hard Disk Drives 55
Formatting ATA Devices 55
Memory Cards 56
SRAM Cards 58
Flash Cards 58
Formatting Cards with FFS2 59
Page 60 60
Opening the CardTalk Control 61
Getting Help 62
Viewing Card Information 62
I/O Cards 63
Memory and Hard Disk Cards 63
Configuring a Memory or Hard 64
Disk Card 64
The Why? Button 65
Current Configuration Box 65
New Configuration Box 65
List Boxes on the Left 65
Apply Now 66
Prepare the Socket(s) 67
Prepare the Card(s) 67
Page 68 68
Copying Files 70
Popup Notification 72
Start Minimized 73
Display Help Bar Text 73
Troubleshooting 74
Initialization Problems 74
TMB250.SYS /IO:nnn 75
Installation Aborted 76
Card Services Not Installed 76
Error in Command Tail 76
Drive Assignment Conflicts 77
Warning Beeps 78
Error Messages 80
Page 82 82
Page 84 84

Comments to this Manuals

No comments

ActionTec PC-260 User's Guide Page 29

Comments to this Manuals

Related products and manuals for Networking ActionTec PC-260